Cricut Cake: Take Two


I sat down with my Cricut Cake again this weekend (and by sat down with I mean stood in my kitchen for hours covered in powered sugar…) and I got down to business on how to get things going with it.

I really need to get some gumtex or tylose powder or get/make some gum paste, but ya know what, I’m a busy girl. I haven’t had time yet.

Anyhow, I incorporated as much powdered sugar into this fondant as it would tolerate in attempt to make it a but more stiff..

Now, when you grease the mat with shortening, don’t glop it on, but make sure you’ve got a nice coating. You want to try to make it as uniform as possible.
photo photo

If you’re seeing a lot of white, it’s probably too thick.

photo photo
I roll the fondant pretty thin and then slap carefully place it on the sheet, trying to avoid air bubbles. Then I cut it down following the guides.
photo photo
If the fondant hangs over that guide line, it’s going to get smushed by the roller thing and it won’t be nice. It’s happened to me several times. Jussayin.

photo photo
I pop the whole thing in the freezer for 10-15 minutes. Let it chill a bit… then load it in to the machine.

photo photo
I’ve had the most luck with medium pressure and low speed.
I chose my image and quantity and hit cut…
photo photo

photo photo

Gibson was pretty unsure about the whole thing. lol

At the end of the night, I’d managed to cut out these things…

Not perfect, but I’m still learning and hey, I was told that marshmallow fondant probably wouldn’t even work with this! So I think I’m doing alright.

Since these photos were taken, I’ve actually decorated two cakes using the machine! You’ll get to see them soon! I need time to get those posts together!

Cricut Cake Day One

Well, I got my Cricut Cake yesterday and started trying to figure it out! I’d read that there’s quite a learning curve involved.

All I had laying around to work with was some week old marshmallow fondant. The machine works best with gumpaste or fondant you’ve added some tylose powder to, so I’ve read.

Anyhow, I didn’t have nearly the disastrous results I’ve read about online. I think the people who have so many issues are either not familiar with working with fondant (and other cake decorating supplies) or not familiar with working with technology lol

There was certainly some set up confusion for me. I didn’t understand where to place the fondant on the mat.
The manual said the bottom left side… So that’s where I put it. Well, that’s where I thought I put it anyway. Evidently I put it in the top… Right? I’m still confused on that one. In any case, it need to be in the top right when you feed the sheet into the machine!


I also found taking the note to stick your sheet in the freezer helped a lot. The manual says to “liberally” coat the mat with shortening… It took me a while to get the consistency right. Not so liberally, as it the case may be. Then I rolled my fondant out pretty thin. Minimum pressure wasn’t hard enough and I ended up doing most cutting at medium pressure and low speed.

I didn’t have much luck with the super intricate designs, but I think I was trying to cut them too small. I had great success with boarders and butterflies though :)
Cricut first cuts Cricut

I have to figure out how to make those boarders connect lol

I want to use the machine on a cake I’m making this week, so I might save myself some headache and make some gumpaste.

Overall, I’m very excited to get into using this! I can’t wait to get more cartridges and start putting out some awesome designs!

And also- mad props to wordpress for the update to their iPhone app. I can’t believe I was finally able to post a decent post from my phone without issue!!!

%d bloggers like this: